Roll Measuring Devices for Paper Industry

• Full automatic, motorized movements
• The measuring device is installed on X-carriage.
• Carbon fiber C-frame is installed to horizontally moving measuring beam (X1-axis).
• 3 short measuring rods + 1 measuring arm of lever type on wheel side.

Applicable for grinders:

• Most of old roll grinders.
• Easy installation to existing Waldrich Siegen CP type measuring device. 4-point upgrade by using the existing X1-beam.

• Full automatic, motorized movements
• Measuring device is mounted on Z-carriage.
• The outer measuring arm is equipped with carbon fiber C-frame.
• The wheel side arm moves up/down.
• 3 measuring rods + 1 measuring arm on the wheel side.

Applicable for grinders:

• Upgrade to existing Herkules measuring device.
• Herkules and other grinders without existing measuring device: New foot and rigid horizontal beam is installed on Z-carriage.

• Semiautomatic, manually adjustable rods.
• The measuring device is installed on grinder's carriage.
• Four measuring rods, roller type. Manual adjustment against roll. Diameter range 400 mm with one C-frame.
• Motorized up-down movement of horizontal measuring beam.
• Carbon fiber C-frames, as many as needed to cover rolls' diameter range.

Applicable for grinders:

• All grinders without existing measuring device.

A cost effective solution when manual measuring device is acceptable.

Roll Measuring Device HYBRID RMD4-3D "Supercalender lathe"

• Semiautomatic, manually adjustable rods.
• The measuring device is installed on lathe's toolpost.
• Four measuring rods, roller type. Manual adjustment against roll. Diameter range 300 mm.
• Pivoted up-down movement and manually adjustable horizontal movement for centering C-frame according to roll's centrum. Manual vertical adjustment.
• One carbon fiber C-frame, for supercalender roll diameter range 500-800 mm (or other 300 mm range).

Applicable for lathes:

• Lathes for turning of supercalender rolls.

The most cost-effective solution.